The peeps on the forums have been experimenting with using coatings on their formlabs trays to extend the life of the PDMS layer. Some even claim after treatment they get better print results. I’ll experiment with one of the suggested products RainX. Crosses fingers. I’ll post an update after some prints.

View this on Instagram
Follow @EmbeddedJunkie

The peeps on the forums have been experimenting with using coatings on their formlabs trays to extend the life of the PDMS layer. Some even claim after treatment they get better print results. I’ll experiment with one of the suggested products RainX. Crosses fingers. I’ll post an update after some prints. #silicone #savingmoney #crafts #DIY #3dprinter #3dprinting #3dprint #3dprinted #3dprints #impresora3d #stereolithography #formlabs #Form1 #form1plus #SLA #makermovement #makerrevolution #makers #makersgonnamake #pdms